Resin Glitter Light Switch Plate Cover

Resin Glitter Light Switch Plate Cover!

How to make a glittery light switch plate cover using glitter and resin!  Customize the color of glitter and top it off with High Gloss Resin for a smooth and shiny finish.  It’s a simple DIY craft that just takes a few minutes of work time and overnight drying.  

SUPPLIES NEEDED:

Switch Cover or Electrical Cover

Envirotex Lite High Gloss Resin

Glitter in variety of colors/sizes

Rubbing Alcohol

Mod Podge

Paintbrush

2 Mixing Cups, 2 Stirring Sticks, Disposable gloves and disposable work surface

GET STARTED:

If you look around the house, you are likely to find a few switch plates that could use a facelift.  Mine is dirty and scuffed, so a glittery update is just what it needed.  Simply clean the plate with rubbing alcohol to remove dirt and oil build up.

Use the Mod Podge or Ultra Seal with the paintbrush and coat the entire plate surface.  Work over the disposable surface for easy clean up.

ADD GLITTER:

To make the ombre glitter effect, pour out a hefty amount of glitter on the lower half of the switch plate.  

I used aqua glitter, my favorite color.  Then gently lift up the switch plate to dump all the excess glitter off onto the work surface.   Lift the paper and pour the glitter back into the jar.

Next pour out the white glitter on the top half of the light switch cover. 

Repeat the process as before by returning the excess glitter back into the jar.  Add some  chunky glitter across the center of the plate…just across the middle.

POUR ON RESIN:

Now set the switch plate on top of some small cups as risers.  Then mix up about 1 ounce of high gloss resin.  I mixed a giant cup full to use with another project, so disregard the quantity pictured.  Just an ounce is plenty for the top of the switch plate.

Set the light plate up on small cups as risers, so the resin can cover the entire surface and the excess drip off the edges.

Use the stirring stick to pour out some of the high gloss resin all over the glitter.  Allow it some time to soak in around the glitter.  The resin is self leveling and will work it’s way around the plate.  Encourage it with the stirring stick to cover the entire top of the switch plate.  Then let the resin dry and cure overnight.

CLEAN UP:

The next day pull the face plate off the risers and use a small hobby knife to clean up the drips and drops on the backside of the plate.

The clean up was super easy to get the little drips removed.

Now the switch plate is ready to hang on the wall.

THAT’S IT!

Doesn’t it look fabulous!?  I love the thick chunky glitter in the center and the sparkly blue shine on the bottom.

Like, Pin and Share!

But that's not all!

I've got a bunch of Resin Crafts here too: